Technical guides

Technical guide

Laser Beam Profiling for Semiconductor Processing

By
Shinhotek LUMOS
Published
2026-11-19

In semiconductor laser processing, small changes in spot size and shape at the work plane move the yield. This note covers what to check per process, where to measure and how to monitor in production.

What to check per process

ProcessTypical beamWhat to check
Wafer dicing, scribingUV or ultrafast focused spotSpot diameter, ellipticity, focus position
MarkingScanner and f-theta focused spotSpot size variation across the field
DrillingFocused spotSpot diameter and roundness
Annealing, lift-offLine beam or top-hatPlateau size, uniformity, edges

When results drift without any process change, a change in spot shape is often the cause rather than laser power.

Where to measure

  • Laser output (raw beam): the laser's own condition and mode, with the LUM-B series
  • After the expander and optics: large expanded beams and top-hats; LUM-B-L for large sizes
  • Work plane (focused spot): the spot that actually hits the part; micrometre spots are measured with LUM-F and its objectives, down to Ø 3 µm at ×20
  • Around focus: when focus position and depth of focus set the process window; LUM-Z travels up to 10 mm along the axis and measures spot size, depth of focus and 3D intensity distribution

UV wavelengths

UV wavelengths common in dicing and micromachining make model choice important.

  • LUM-B-D (LUM-B-DUV): 200–1064 nm, reflective ND filters for DUV/UV
  • LUM-F-DUV: 240–355 nm
  • LUM-F-UV: 343–355 nm

Focused spots for 355 nm dicing are measured with LUM-F-UV or LUM-F-DUV.

Production line monitoring

Measuring regularly under the same conditions catches problems earlier than a one-off check.

  • Set reference values at a fixed position and exposure and compare diameter, ellipticity and centroid
  • Connect several LUM-B cameras to one Lumosity instance to watch multiple laser heads
  • Send results to the machine's PC software over Lumosity's XML protocol on TCP/IP for automatic pass/fail

Checklist

  • Was the work-plane spot re-measured after optics replacement or alignment?
  • Were spot sizes compared at the center and edge of the scanner field?
  • Was the laser warmed up and the background frame subtracted?
  • Was the sensor kept out of saturation?
  • Are reference values and conditions (exposure, ND, position) recorded?

Contact

Tell us the process, wavelength, spot size and measurement position and we will propose a model and setup.